Complete specifications of U-shaped wire rope clips for supply card head buckles.

Why Wire Rope Clips Cannot Be Used Indiscriminately Without Distinguishing Left and Right

As is well known, the primary purpose of wire rope clips is to secure the ends of wire ropes. Typically, the outer layer of a wire rope consists of six strands twisted at an angle in a right-hand direction. However, not all wire ropes on the market are right-hand twisted; left-hand twisted ropes are becoming increasingly common. According to the national standard GB/T5976-2006 for wire rope clips, it is explicitly required that the surface of the wire rope must align with the groove direction of the clip in terms of twist orientation. From this, it can be inferred that if the wire rope is left-hand twisted, a left-hand twist wire rope clip must be selected to comply with usage standards. Due to cost competition in the market, most products are primarily made of ordinary cast materials (including cast iron, also known as malleable iron), and market demand factors have led to the absence of left-hand twist clips. Some gray iron cast clips are even used for critical wire rope applications. According to the national standard GB/T5976-2006 for wire rope clips, when wire rope clips are used on lifting machinery, it is recommended to use (nationally standard forged) wire rope clips for better performance. Tieren Machinery, based on customer needs, can provide wire rope clips in sizes ranging from 6mm to 60mm, fully meeting national standards for both left-hand and right-hand twist specifications. The manufacturing process is forging, and the mechanical properties of the selected materials meet or exceed standard quality requirements. In the era of economic development and progress, standardized products are increasingly valued by users. Correct selection and standardized usage are becoming deeply ingrained.